14/01/2023 1:27 am
Topic starter
Notifications
Clear all
DIY Ideas
2
Posts
2
Users
0
Likes
444
Views
0
What is the connector type / size for the BlakBullet Cable ? I would like to make a spiltter cable to connect 2 switch to 1 port on the BlakBullet hub .
2 Answers
0
14/01/2023 9:01 am
The connector is a standard 2.5mm DC plug. However, the diameter is smaller than normal and is custom made for us. You can purchase the cables from us. Or you can try using standard cables and cut down the diameter so it fits inside the hub.
0
15/01/2023 3:08 pm
Topic starter
I prefer the DIY Blak Bullet Cable as I like the cable quality but I need a splitter cable, either 3 Female to 1 male or 4 female to 1 male. Cutting standard cables are just too much trouble. Most of the female connector/jack for 2.5mm*0.7mm DC is quite large.
A prefab splitter cable with the different / appropriate resistor already installed on the positive wire of the female connector would make it alot easier for DIY.
